Open Hardware
Assembly Instructions

1x [AS-TH0089] Twin Nebula 285 (0.5mm), LGX Assembly
1x [DC-LB0012] White 7 x 1/2 x 2 laser label
1x [DC-LB0160] Tool Head Serial Number Sticker, Matte Silver, 1" x 0.5", Thermal
1x [DC-LB0230] T.B.D. TWIN NEBULA 285 LABEL
1x [DC-MS0054] Firmware Update Warning Cards
1x [DC-MS0060] CONGRATULATIONS!- Accessory Instruction Card, V1.2
1x [EL-HR0230] Twin Nebula E0 Jumper
1x [EL-HR0231] Twin Nebula E1 Jumper Harness
1800mm [HD-TB0007] Feed Tube, 0.187" ID X .250" OD NAT PTFE Tube
1x [PP-GP0430] Tube Collar 1, Pro
1x [PP-GP0431] Tube Collar 2, Pro
1x [SH-PA0016] 8 X 8 Convoluted Foam 2 pc Set
1x [SH-PA0066] TAZ Pro, Tool Head Korrvu 8" x 8" x 6" Outer Box
1x [SH-PG0003] 4 x 6" 2 Mil Reclosable Polypropylene Bags 1,000/carton
812.8mm [SH-PG0131] Custom Printed LulzBot White Tape

3A) Turn on the tape machine and the heater. The heater should be on for 20-30 minutes before using.

3B) Grab 1x SH-PA0066. Fold up the box and secure the bottom using a 16in. (Short Length if in Tool Heads) piece of tape.

3C) Clean up the corners of the box using a side cutter.

3D) Place the back label from DC-LB0230 on the back of the box and place the front label from DC-LB0230 on the front of the box. Note the box orientation.

3E) Place DC-LB0012 on the inside of the back flap of the box as shown.

3F) Place one half of SH-PA0016 in the box. Place 1x DC-MS0054 and 1x DC-MS0060 in the back of the box between the foam and box.

3G) Place the two tubes in the box.

3H) Place AS-TH0089 in the box.

3I) Place the jumper cables kit in the box.

3J) Place the other half of SH-PA0016 in the box. Close the box and secure using a 16in. (Short Length if in Tool Heads) piece of tape.

3K) Clean up the corners of the box using a side cutter.

3L) Place 1x DC-LB0160 on the front label where shown.