Open Hardware
Assembly Instructions

Parts:

1x- Z switch mount (PP-GP0216)

1x- Wiper Mount (PP-GP0231)

1x- Wiper pad (AS-PR0023)

4x- Bearings Holder (PP-GP0233) (with bearings installed)

4x- Bed corners (PP-GP0221)

1x- Y belt mount (PP-GP0222)

1x- Bed plate

4x- Bed standoffs

1x- Momentary switch and retention nut

2x- SPDT switches

1x- M3x16 FHCS

30x- M3x8 BHCS

4x- M2x10 SHCS

1x- M3x10

30x- M3 black washers

4x- M2 washers

Tools:

5.5mm Nut driver

1.5 mm Hex driver

2.0mm Hex driver

Flip the plate over;

Install the momentary switch into the Z mount switch toque to 3in*lbs

Correct the orientation of the two switch contacts to a perpendicular orientation to the cable pathway (seen to the right of the switch)

Loosely secure the Z switch mount to bed plate. Use one (1) stainless M3X16 FHCS towards the inside of the plate, one (1) M3X10 BHCS and one (1) M3 Black washer on the other side. These will be tightened later when the bed is installed.

Loosely secure the Y bearings to the assembly using sixteen (16) M3X8 BHCS and sixteen (16) M3 black washers

Install two (2) SPDT switches using two (2) M2x10 SHCS, secured to hand tight, and two (2) M2 washers onto each end of the Y belt mount with wiring terminals facing each other and the switch actuator away from the plate

Install the belt mount as shown using four (4) M3X8 BHCS, tightened to 3 in-lbs (~.35 N-m), and four (4) M3 Black washers making sure the long switch side is toward wiper mount side of the bed plate.