Open HardwareAssembly Instructions
Guides for installation and assembly of the LulzBot line of products made by FAME 3D LLC.
Guides for installation and assembly of the LulzBot line of products made by FAME 3D LLC.
The first thing we will do is gather our materials.
AS-PR0152 - Scotch bright pad x1
TL-HD0049 - Tweezers x1
XX-XX0000 - Elmers glue x2
TL-HD0008 - Ruler
One red pen
One mixing container
You will need to measure out the individual pads from the main sheet. Each wiper pad will measure 90 mm long and 25 mm wide. You should be able to get 14 pads per sheet. There will be a little left over. Use the red pen to mark the measurements for the pads.
Using a pair of scissors go ahead and cut out the pads.
To make the slurry use two bottles of elmers glue and mix it with 48 fl oz of hot water. Rinse the bottles with water to get all the glue out. Use the tweezers and dip the pad in the slurry. Make sure to dip and not soak the pad.
Place the dipped pads on a drain-able surface. It is also a good idea to place some paper towels below the trey.
Now give the pads time to dry. The best way to do this is to place them in a dehydrator set at 158° F for 2 hours.
Before removing the wiper pads from the dehydrator make a mark on the top side of each wiper pad. You can use the same red pen or any other marking utensil.
Once the wiper pads have had time to dry we can remove them from the trey. To do this use your fingers to pop them off the trey. Make sure to do this quickly like ripping off a band-aid. If you do it too slow, pieces of the pad will stick to the trey.
Re-dip the wiper pads in the slurry. Keep in mind the slurry will start to separate after time so you will have to stir it up a little.
Place the pads back in the dehydrator with the mark facing down. Again set the dehydrator to 158° F and dry for 2 hrs.
Once the pads are dried all the way, remove them the same way we did before. Remember to make it quick when removing the pads.
