Open Hardware
Assembly Instructions

Unplug the USB from the front of mini

Unplug the power cord from the back of mini

Move spool arm down position

Turn Mini over so that handle is on the table/ground

Using the 2 mm hex, unscrew the 4 bed screws

When bed screws are all the way out, bed washers will also come off

Put the room temperature bed in a freezer for 60 minutes

Take the razor blade and pry up one of the corners of the PEI from the glass bed

Pull PEI away from glass bed (this make take some strength)

Remove adhesive starting from the center moving outwards (the edges of the glass may dull your razor blade so it's best to start from the center and then do edges last)

If it seems impossible to remove adhesive you may need a new razor blade

Pour on more isopropyl as needed

Place the edge of PEI that you peeled away flush with one side of the bed. You can choose any side for this (the PEI sheet is bigger than glass bed we will trim the excess in later step)

Using a rubber squeegee/spatula push the adhesive into the glass bed as you remove the back protective cover

Once the PEI is on the bed use squeegee/spatula to push out as many excess bubbles that you can

Place the glass bed back onto the the bed plate with the wires facing to the left

If the steel spacers have fallen out, push them back in the ninja flex

Put the screws into the washers, then place them into the steel spacers, use your 2mm hex to screw them back in (screws should be snug but not over tightened)

There should be 4 screws, 4 washers and 4 spacers