OHAI: Open Hardware Assembly Instructions

1 Make sure that you have all required parts and tools

-2mm hex screw

-Scissors/other tool to cut zip tie

-Zip tie

Required tools

2 Unplug & move spool arm

-Unplug the USB from the front of mini

-Unplug the power cord from the back of mini

-Move spool arm down position

-Turn Mini over so that handle is on the table/ground

Move spool arm down

3 Remove zip tie/Unplug connectors

-Pull the bed forward toward you

-Cut zip tie with scissors/other tool to cut zip tie

-Pull zip tie out

-Pull bigger connector apart

-Push tab then pull smaller connector apart

Cut zip tie

Pull the 2 bed connectors apart

4 Remove 4 bed screws/washers

-Using the 2 mm hex, unscrew the 4 bed screws

-When bed screws are all the way out, bed washers will also come off

-Remove bed

Remove 4 bed screws/washers

Remove bed

5 Place new glass bed on bed plate

-Place the glass bed back onto the the bed plate with the wires facing to the left.

-If the steel spacers have fallen out, push them back in the ninja flex.

-Put the screws into the washers, then place them into the steel spacers, use your 2mm hex to screw them back in(screws should be snug but not over tightened).

-There should be 4 screws and 4 washers and 4 spacers.

Place glass bed on bed plate

Steel spacers

Place screws/washers into steel spacers

Location of 4 spacers/screws/washers

6 Plug connectors and place zip tie

-Now that the bed is secure again turn your mini upside down.

-Plug the bed connectors back in

-Place zip tie through the top hole in the larger connector

-Then route the zip tie around the first rung on the harness guard and through the second hole on the larger connector

-Tighten and clip the zip tie

Plug two connectors back in

Zip tie through first hole in large connector

Zip tie through harness guard and back through second hole in connector