OHAI: Open Hardware Assembly Instructions

1 Gather Materials

1x- [AS-TH0074] TAZ Pro Dual Extruder Tool Head
2x- [HD-TB0007] TAZ Pro, Feed Tube
1x- [DC-MS0054] Firmware Update Warning Cards
1x- [DC-LB0213] TAZ Pro, Front and Back Label
1x- [SH-PA0066] TAZ Pro, Tool Head Box 8" x 8" x 6"
1x- [SH-PA0065] TAZ Pro, Tool Head Korrvu Insert
1x- [SH-PG0131] #260 White Reinforced Gummed Tape with LulzBot Printed Logo

Materials gathered

2 Fold Box

Take the flattened TAZ Pro, Tool Head Box 8" x 8" x 6" [SH-PA0066] and unfold it so it stands up, then take the two bottom tabs that are next to the tab with the red stamp and fold them in,

Next fold in the tab with the red stamp and the tab across from it.

Take a piece of packing tape and tape the bottom of the box

Unfold the box from the flatten position

Fold in the bottom tabs make sure the red stamp is on the outside

Tape the bottom of the box

3 Place Dual Extruder Tool Head into Korrvu

Fold the two sides without the finger holes up so that there is space for the tool head under the plastic wrap

Place the TAZ Pro Dual Extruder Tool Head [AS-TH0074] under the plastic wrap on the Korrvu [SH-PA0065]

Fold the left side of the Korrvu back then fold the right side back then fold the top and bottom side up so it holds the left and right sides folded back so the plastic wrap is stretched around the tool head

Then place the Korrvu and tool head inside the box

Fold the left and right side of the Korrvu (two sides without the finger holes)

Place TAZ Pro Tool Head under the plastic wrap

Fold the left and right side of the korrvu

Fold the top and bottom side of the korrvu

Place the Korrvu and tool head inside the box

4 Add Accessories

Place 2x Feed Tubes [HD-TB0007] inside the box onto of the tool head.
Note: wrap the two feed tubes into a circle

Next place the CONGRATULATIONS! Accessory Instruction Card [DC-MS0060] on top of the tool head and place the Firmware Update Warning Card [DC-MS0054] over the congratulations card

Place the feed tubes in the box over the TAZ Pro Tool Head

Place the congratulation card on top of the tool head

Then the Firmware Update card

5 Close and Tape Box

Now close the box and take it to the Uline tape machines.

Use #260 White Reinforced Gummed Tape with LulzBot Printed Logo [SH-PG0131]

Select the short length on the machine.

Place the tape on one of the tabs about half way on, then fold the tab in so the tape secures both tabs together then make sure the tape runs down both sides of the box to secure the box from opening

Close the box

Tape the two tabs shut

make sure the tape runs down both sides of the box

6 Add Labels

Place the Front TAZ Pro Label [DC-LB0213] on the front of the box, then place the Back TAZ Pro Label [DC-LB0213] on the back of the box.

Note: The front label is on the top of the sheet and the back label is on the bottom

Place the front TAZ Pro label