OHAI: Open Hardware Assembly Instructions

1 Gather Materials for Packaging

Materials needed:

1x- [AS-TH0068] Titan Aero Assembly, Micro
1x- [DC-LB0172] SL Tool Head Label, Front
1x- [DC-LB0173] SL Tool Head Label, Back
1x- [DC-MS0054] Firmware update warning
1x- [DC-MS0060] CONGRATULATIONS!- Accessory Instruction Card
1x- [DC-MS0073] Filament Warning Insert, 8.5" x 2", Astrobrite Lift Off Lemon
1x- [SH-BX0088] Accessory Tool Head Box: 9-1/2 x 7 x 3-7/8 Die Cut, 32 ECT, B Flute, Kraft, White
1x- [SH-PA0049] Korrvu Medium Retention Pack for Standard Tool Heads
1x- [SH-PG0131] #260 White Reinforced Gummed Tape with LulzBot Printed Logo, 10 Pack
1x- [DC-LB0174] P65 Warning Label

Gather Materials

2 Fold Box

Take your unfolded box [SH-BX0088] placing so that the brown side is facing you and start by folding up the flaps on the left and right sides of the box as shown.

Next fold the bottom side (side with the semicircle cut) up, as shown.

Now take the left flap on the bottom side and fold it then repeat for the right flap and fold the top flaps toward the middle of the box, as shown.

Then fold the left and right flaps over the flaps on the bottom side of the box and make sure they are secured in the two open slots, as shown

Lastly fold the top flap backwards

Fold left side

Fold right side

Fold left flap on bottom side

Fold right flap on bottom side and fold bottom side down

Flip box over and fold down the left and right sides

Fold the top side backwards

3 Place SL Tool Head into Korrvu

Fold the two sides without the finger holes up so that there is space for the tool head under the plastic wrap

Place the Titan Aero SL Tool Head [AS-TH0068] and the Filament Warning Card [DC-MS0073] under the plastic wrap on the Korrvu [SH-PA0049]

Fold the left side of the Korrvu back then fold the right side back then fold the top and bottom side up so it holds the left and right sides folded back so the plastic wrap is stretched around the tool head

Then place the Korrvu and tool head inside the box

Fold the left and right side of the Korrvu (two sides without the finger holes)

Place SL Tool Head and filament warning card under the plastic wrap

Fold the left and right side of the korrvu

Fold the top and bottom side of the korrvu

Place the Korrvu inside the box

4 Add Cards

Place the CONGRATULATIONS! Accessory Instruction Card [DC-MS0060] on top of the tool head and place the Firmware Update Warning Card [DC-MS0054] over the congratulations card

Place the congratulation card on top of the tool head