OHAI: Open Hardware Assembly Instructions

1 Gather tools and components for assembly

Components Required

Bed plate
Belt mount
Bed corners
Wiper mount
M3x12 SHCS
M3x8 BHCS
M3x6 flat head screw
M3 washer
M3 Nyloc nut
M3x8 spacer
Male cable guide connector
Bed wire harness

Tools

2.5 mm Allen driver
2 mm Allen driver
5.5 mm wrench
Plate holder

Tools

2 Install bed corners

Mount the 4x bed corners to the bed plate using 8x M3x8 BHCS and M3 washers as shown making sure you just secure them finger tight, don't squish the bed corners.

The side of the bed plate with the two recessed holes is the top mounting surface.

Bed corner fastend

All four on, note orientation

3 Add Belt mount

Fasten the belt mount to the bottom of the bed plate using 3x M3x8 BHCS and M3 washers as shown.

You can use the bed plate holder if needed.

Belt mount and hardware

Bed plate holder

Bed plate in holder

View of belt mount secured from top

Belt mount from back

4 Add the wiper mount

Attach the wiper mount to the bed plate using 2x M3x8 BHCS, M3 washers as shown.

Note orientation.

Wiper mount and hardware

Orientation

5 Add the male cable guide connector

Add the male cable guide connector using 2x M3x6 flat head screws as shown.

Connector and hardware

Installed, note orientation

6 Add the bed harness

Connect the bed harness to the cable tracks connector. Reference pictures for orientation.

Secure black ground lug to bed with 1x M3x8 steel bolt and star washer. Make sure the star washer is under the ground lug and touching the bed.

Attach nyloc nut to secure ground lug to bed.

Harness and hardware

Orientation of harness

Ground lug fastened