Project Dashboard Hot End & Tool Head Assembly Mini Print Head Assembly Workflow

1 Gather tools and components for assembly

Components Required

  • Extruder Assembly
  • Extruder Mount
  • Nozzle Assmebly
  • Hex mount plate
  • M2x6 SHCS
  • M2x10 SHCS
  • M2 Washer
  • M3x12 SHCS
  • M3x14 Flat head screw
  • M3 Washer
  • M4x25 SHCS
  • M4 Washer
  • 40 mm Fan
  • Fan Mount
  • Limit Switch
  • Black and purple limit switch wires
  • Blower Fan
  • 20 POS connector
  • 75 mm Panduit

Tools Required

  • 1.5 mm Allen driver
  • 2 mm Allen driver
  • 2.5 mm Allen driver
  • 3 mm Allen driver
  • Piece of filament
Tools

2 Assemble the print head

Place the hex mount plate onto the nozzle as shown.

Sandwich the hex mount in between the extruder mount and the extruder body as shown making sure all the wires are to the back and right.

Slide a piece of filament through the body and into the nozzle to ensure alignment.

Using 2x M4x25 SHCS and M4 washers secure the extruder mount, nozzle, and body together.

Make sure the heater block is aligned straight down evenly as shown.

Pull the piece of filament out making sure it slides through smoothly.

Hex mount plate placed on nozzle, note orientation
Nozzle up in place with extruder mount to the side
Extruder mount in place
Filament in place
Bolts fastened and nozzle aligned properly

3 Attach the blower fan

Attach the blower fan with a M2x6 SHCS as shown.

Blower fan and screw
Blower fan attached

4 Assemble and attach extrusion fan

Prep the limit switch by connecting the black and purple wires as shown. Note the orientation of switch and wires in pictures.

Attach the limit switch to the fan mount using 2x M2x10 SHCS and M2 washers as shown.

Attach the fan mount to the extruder mount using 2x M3x14 flat head screws as shown, make sure the blower fan wires are tucked under the fan mount, reference pictures.

Make sure not to pinch any wires with the fan mount.

Attach the 40 mm fan to the fan mount using 2x M3x12 SHCS as shown. Note orientation of fan and wires in pictures.

Make sure all the wires are tucked behind the limit switch as shown.

Components and hardware
Switch and wire orientation
Switch attached
Fan mount attached, note blower fan wires
Another view of fan mount
Fan and hardware
All the wires tucked behind the limit switch wires
Fan attached

5 Connect all the wires into the 20 POS connector

Insert all the wires into the 20 POS connector using the diagram in the next step.

Note the triangle on the connector is position #1 on both the connector and diagram.

Components
Connector, note triangle

6 Connect all the wires into the 20 POS connector

Diagram

Diagram

7 Add panduit

Place a piece of 75 mm panduit over the wires as shown.

Components
Complete
Done! Take me home