OHAI: Open Hardware Assembly Instructions

1 Gather parts for the Y plate assembly

Components:
- Y bed plate
- Y belt holder
- Singe bearing holder with inserts
- bed finger
- bed corner
- belt clamp
- Extruder (bed) spring
- M3 x 12 SHCS
- M3 Washer
Tools:
- 2.5mm Allen Driver
- TL-FX0011

2.5mm allen driver

TL-FX0011

2 Install the Y belt mount

Install the Y belt mount onto the Aluminum plate using 4x M3 x 12 SHCS and M3 washers.
Tighten bolts all the way down.

Y belt mount parts

Belt mount from the top

Belt mount from the bottom

3 Install the Single bearing holders

Install bearing holders using M3 x 12 SHCS and M3 Washers.
Orient the step in the bearing holders towards each other.
Make the bolts tight enough that the bearing holders can't move up and down, but can still move side to side.

Parts to install single bearing holders

Fixture holds plate during assembly

Bearings installed

Bearing holders from bottom

4 Install bolts for glass mounts

Install 4x M3 x 12 SHCS into corners of Aluminum plate.
Take close note of bolt locations.

Install Bolts for corners

Bolts shown installed

5 Install the bed corners and fingers

Install bed corners using a M3 x 12 SHCS, M3 washer and a extruder (bed) spring.
Set the end of the bolt flush with the bottom of the plate for now.
Install bed finger as shown using a M3 x 12 SHCS and M3 washer.
Repeat in all 4 corners.

Bed corner parts