Included materials vary depending on tool head. See the links below for materials included with each compatible tool head.
The tool head is attached with three screws. The print surface can be damaged if the tool head is allowed to fall onto the print surface. With one hand, support the tool head while following removal steps below.
Using the 2.5mm hex key, unscrew the three M5 screws securing the tool head to the X-axis carriage. Remove the rear screw first, followed by the remaining top two screws.
Remove the tool head from the printer by moving the tool head away from the printer.
Press the tool head onto the X-axis carriage, aligning the cutouts on the back of the new tool head. Do not pinch any wires between the mount and the carriage.
Secure it to the X-axis carriage by loosely screwing in the top two screws. Leave the top two screws loose.
Loosely screw in the last screw through the rear of the X-axis carriage.
Tighten the top two screws.
Tighten the rear screw.
Cover the connector with the carriage cap and attach it to the X-axis carriage using the three M3 screws and the 2.5 mm hex key.
Channel the wires together going to down the vertical pathway on the cover mount, and try not to pinch any of the wires when securing the cover. Slide down carefully into place, and hold while screwing in.
Note: The cover may not fit on certain tool heads such as the M175 v2.
Install the latest version of Cura LulzBot Edition. It is important to have the LulzBot Edition of Cura, as it has preset machine configuration profiles built into it.
Go here to install http://LulzBot.com/Cura.
Plug in your LulzBot 3D printer to the power supply and power on your 3D printer.
Once powered on, connect your 3D printer to your computer using the USB cable.
Open Cura LulzBot Edition.
From the drop-down menu at the top right-hand side of Cura LE, Select Manage Printers.
Confirm that the LulzBot TAZ Workhorse, SL | 0.25mm is selected, and click Upgrade Firmware.
(if you are using a different tool head, confirm the corresponding option)
Select Automatically Update Firmware. The Update EEPROM checkbox should be checked by default. Close any dialog windows after the firmware has been updated.
Filament Loading Tip: Cutting the filament at an angle will help with inserting into the extruder.
Load the sample filament into the extruder. Squeeze the idler arm inward and insert the filament into the extruder filament guide.
Extrude filament until you see the filament extruding from the nozzle
You've now finished installation and are ready to start printing! Try performing a test print, such as the Rock2pus.
If you encounter issues please contact Technical Support by emailing Support@LulzBot.com, or by calling +1-701-809-0800.