Guides for installation and assembly of the LulzBot line of products made by FAME 3D LLC.
1x- [AS-TH0074] TAZ Pro Dual Extruder Tool Head
2x- [HD-TB0007] TAZ Pro, Feed Tube
1x- [DC-MS0054] Firmware Update Warning Cards
1x- [DC-LB0213] TAZ Pro, Front and Back Label
1x- [SH-PA0066] TAZ Pro, Tool Head Box 8" x 8" x 6"
1x- [SH-PA0065] TAZ Pro, Tool Head Korrvu Insert
1x- [SH-PG0131] #260 White Reinforced Gummed Tape with LulzBot Printed Logo
Take the flattened TAZ Pro, Tool Head Box 8" x 8" x 6" [SH-PA0066] and unfold it so it stands up, then take the two bottom tabs that are next to the tab with the red stamp and fold them in,
Next fold in the tab with the red stamp and the tab across from it.
Take a piece of packing tape and tape the bottom of the box
Fold the two sides without the finger holes up so that there is space for the tool head under the plastic wrap
Place the TAZ Pro Dual Extruder Tool Head [AS-TH0074] under the plastic wrap on the Korrvu [SH-PA0065]
Fold the left side of the Korrvu back then fold the right side back then fold the top and bottom side up so it holds the left and right sides folded back so the plastic wrap is stretched around the tool head
Then place the Korrvu and tool head inside the box
Place 2x Feed Tubes [HD-TB0007] inside the box onto of the tool head.
Note: wrap the two feed tubes into a circle
Next place the CONGRATULATIONS! Accessory Instruction Card [DC-MS0060] on top of the tool head and place the Firmware Update Warning Card [DC-MS0054] over the congratulations card
Now close the box and take it to the Uline tape machines.
Use #260 White Reinforced Gummed Tape with LulzBot Printed Logo [SH-PG0131]
Select the short length on the machine.
Place the tape on one of the tabs about half way on, then fold the tab in so the tape secures both tabs together then make sure the tape runs down both sides of the box to secure the box from opening