1x- [AS-TH0076] HE 0.5mm Tool Head
1x- [DC-LB0194] HE 0.5mm Tool Head Label, Front
1x- [DC-LB0195] HE 0.5mm Tool Head Label, Back
1x- [DC-MS0054] Firmware Update Warning Cards
1x- [DC-MS0060] CONGRATULATIONS!- Accessory Instruction Card
1x- [SH-BX0088] Accessory Tool Head Box
1x- [SH-PA0049] Korrvu Medium Retention Pack for Standard Tool Heads
1x- [SH-PG0131] #260 White Reinforced Gummed Tape with LulzBot Printed Logo
1x- [DC-LB0174] P65 Warning Label
Take your unfolded box [SH-BX0088] placing so that the brown side is facing you and start by folding up the flaps on the left and right sides of the box as shown.
Next fold the bottom side (side with the semicircle cut) up, as shown.
Now take the left flap on the bottom side and fold it then repeat for the right flap and fold the top flaps toward the middle of the box, as shown.
Then fold the left and right flaps over the flaps on the bottom side of the box and make sure they are secured in the two open slots, as shown
Lastly fold the top flap backwards
Fold the two sides without the finger holes up so that there is space for the tool head under the plastic wrap
Place the HE 0.5mm Tool Head [AS-TH0076] under the plastic wrap on the Korrvu [SH-PA0049]
Fold the left side of the Korrvu back then fold the right side back then fold the top and bottom side up so it holds the left and right sides folded back so the plastic wrap is stretched around the tool head
Then place the Korrvu and tool head inside the box
Now close the box and take it to the Uline tape machines.
Use #260 White Reinforced Gummed Tape with LulzBot Printed Logo [SH-PG0131]
Select the 12" length on the machine.
Place the tape with slightly more depth on the top of the box.
Now we will fold the sides inward.
Lastly, fold the tape down securing the lid of the box closed.