Install the power switch, noting the orientation. FYI, switch may be hard to press in.
Install the zip tie bases as shown by peeling the backing off. The middle of the base should be centered about 5 mm from the bolt holes.
Install the power cable receptacle with 2x M3x6 flat head screws as shown.
Attach the two ground wires to the case. Place the wires onto the post using this order: M3 star washer, 50 mm green wire, M3 star washer, 80 mm green wire, then M3 nyloc nut. Plug the spade connector onto the receptacle as shown.
Attach the 4 Pos connector to the power supply by removing the four screws. Place the wires in the correct position as shown.
Take the black and white(260 mm length) wires and attach them to the power supply as shown.
Install the power supply using 4x M3x6 flat head screws as shown.
Hook up the green ground wire to the power supply as shown.
Attach the black and white wires to the power switch as shown.
Connect the black and white(560 mm length) wires with the spade connectors from the switch to the plug as shown.
Make sure to wrap the wires four times around the ferrite alternating the wires as shown.
Wrap wires bottom to top.
Next, zip tie the four black and white wires to the zip tie bases making sure the slack is pulled and the wires aren't touching the bottom of the case and all the slack is towards the top as shown.
Install the 80 mm fan using 4x M3x20 flat head screws, M3 washers, then M3 nyloc nuts.
Note orientation of fan.