Corrugated tubing 100mm
Route switch extension wires though X end motor mount.
Plug switch extension wires onto limit switch.
Secure with set screw.
Plug in X-motor wire.
Zip tie one end of the extension to the motor mount as shown. Zip tie the other end to the plug.
Route wires through relief position # 1
Plug in wires as shown and put ground lug onto post.
Loosen Y table mounts and Y mount chassis to allow for adjustment
Square frame using fixtures
Tighten Y table mounts, Y mount chassis and thumbscrews (Don't over-tighten thumbscrews as they are disassembled for shipping)
Make sure Y axis is sitting flush on frame with no gaps in between extrusions
Note: The number 2 LCD wire connects to 2 plugs, the number 1 wire connects to just 1 plug.
With the number 2 LCD wire on top, feed both wires through the electronics case and around the back side of the closest extrusion.
Looking from the back of the printer, plug the number 2 wire into the furthest right plug on the back of the LCD. Plug the number 1 wire into the other plug.
Keeping the wires as straight as possible, add 3 zip ties as shown. Leave some slack for the LCD plugs at top of wire.
Connect the wires to the RAMBo in the positions shown. Note: The arrow on each plug indicates the upper left hand pin position.
Install the power plug into the electronics case using 4 4-40 x .25 Flat head screws. The single large key slot in the plug should be towards the top of the printer.
Insert the 6 pin power connector into the plug on the top right of the RAMBo board.
Run the power wires from the 6 pin connector through the square hole in the top of the electronics case. Connect the two wires to the 'OFF' side of the power switch.
Run the wires from the power plug through the square hole and connect them to the 'ON' side of the power switch.
Snap the power switch into position on the electronics case. Note: Make sure the 'OFF' position of the switch is towards the front of the printer.
Make sure the switch is in the 'OFF' position.