Project Dashboard Hot End & Tool Head Assembly TAZ 5 Print Head Assembly Workflow

1 Updates to Assembly

Please note when building this assembly that there have been a few changes to this assembly since this workflow was written.
These changes include:
.5mm Nozzle on HotEnd instead of .35mm
Single 16pin Connector Housing instead of multiple connectors

Please ensure when building AS-TH0049 that a .5 nozzle is used and follow the pinout diagram in this step for wiring the extruder.

AS-TH0049 Pin-Out Diagram

2 Gather tools and components for assembly

Components

  • Extruder assembly
  • Extruder mount
  • Lulzbot hexagon with .35 nozzle
  • Aluminum mounting plate
  • 6 M3x12 SHCS
  • 2 M3 washer
  • 2 M4x20 SHCS
  • 2 M4 washer
  • 2 M4 hex nuts
  • 1 M2x6 SHCS
  • 1 Zip tie
  • Mini blower
  • 40 mm fan
  • Fan duct

Tools

  • Flush cutters
  • 1.5 mm allen driver
  • 2.5 mm allen driver
  • 3 mm allen Driver
  • Short piece of 3 mm filament
  • Red Paint Pen
Tools for assembly
Paint Pen

3 Assemble the print head

Place aluminum plate onto hex nozzle grooves, then place onto extruder body.

Place extruder mount on the top of hex nozzle. Hex nozzle should have yellow paint around (360 degrees) the connector.

Using the the M3 allen, screw 2 M4x20's with washers into the 2 M4 nuts held by your finger on the extruder mount(leave these to M4 screws loose for now).

Face hex nozzle forward, tighten M4 screws, check that filament feeds through body and into hex nozzle without catching(you may need to push the aluminum plate to the right while tightening the M4's, so that the filament does not catch).

Verify gears don't rub on extruder body.

Required parts
Place aluminum plate with hex onto extruder body
Extruder mount fits onto hex
Hold the M4 nuts as you screw in M4 SHCS screws
Align the extruder mount to hex nozzle hole
Verify that gears don't rub on exturder body

4 Attach fans

Attache the 40mm fan using the 2.5mm allen, screw in 4x M3x12 SHCS (Note fan orientation). 40mm fan should have red paint around (360 degrees) the 2-pin connector.

Align hex nozzle wires under fan duct, then screw in 2x M3x12 SHCS with washers to the extruder body.

Using the 1.5mm allen, screw one M2x6 mini blower on.

Make sure Mini blower has a 3-pin connector with yellow paint around (360 degress) the connector.

Ensure mini blower is aligned with hex heat sink.

Required parts
Red paint around 40mm blower fan connector
Screw in 4x M3x12 SHCS (Note fan orientation)
Align hex nozzle wires under fan duct, screw in 2x M3x12 SHCS with washers
Mini blower 3 pin connector with paint
Screw Mini blower on using M2x6
Ensure mini blower is aligned with hex heat sink

5 Zip tie wires

Route wires around motor, then zip tie wires where the motor wire get larger.

Tighten and clip zip tie using flush cutters

Route wires around motor, then zip tie wires where the motor wire get larger
Tighten and clip zip tie using flush cutters
Complete
Done! Take me home